Aug 05, 2022 Leave a message

Why are zirconium beads easily broken during grinding

Zirconia microbeads (hereinafter referred to as "TZP" zirconium microbeads) are the first in my country to use micron and sub-nanometer raw materials and are manufactured with advanced technology. All technical indicators and performance have reached the international advanced level.

It is mainly used for ultra-fine grinding and dispersion of "zero pollution", high viscosity and high hardness materials such as electronic ceramics, magnetic materials, zirconia, silicon oxide, etc. It is usually used in sanders. It is the main grinding medium for fine grinding in sand mills, and according to the manufacturer's requirements, grinding zirconium beads of different diameters are selected.

After selecting zirconia beads, how to use them correctly, avoid damage to zirconia beads, and try to prolong the service life of grinding media and contact parts of sand mill.

Reasons for bead breakage:

Glass beads, zirconium silicate beads and pure zirconium beads are popular in the market. As far as the production process is concerned, there are basically two methods: electrofusion and sintering. Beads in hot air are formed in cold air or electrolyte, as in key technologies

If the parameters are not properly controlled, the following brittle beads will be produced:

1.1 Bubble beads

1.2 Snowman Beads

1.3 tail bead

1.4 Flat (oval) beads are broken, so try to avoid such beads when choosing beads.

Because the beads described above have areas of stress concentration, it is easy to clean the machine with low viscosity liquids during the grinding process, and the beads can wear away other beads or contact parts of the sander.

For the longest life of the bead and sand mill, it is best to use resin for cleaning and maintain adequate material viscosity during production.

First, identify the appearance of "broken beads". If the particles are smooth, rather than sharp edges (like broken glass), they are naturally worn beads. These beads can be ground into various shapes such as discs, ovals or smaller balls. This condition is called wear. The only difference is the degree of wear.

If a low viscosity liquid is used to clean the machine, the beads will wear away other beads or contact parts of the sander. For maximum bead and sander life, it is best to use resin for cleaning and maintain adequate material viscosity during production.

_20220305140224

Send Inquiry

whatsapp

Phone

E-mail

Inquiry