All components in the conveyor system are subject to high wear during operation, and these poor wear can be attributed to the occurrence of problems such as corrosion and agglomeration. It is because of the existence of these problems that the benefit of the entire conveying system is significantly reduced, the tension of the conveyor belt is reduced, the unconventional accumulation of materials is caused, and the noise level is increased. We provide you with special rubber materials to meet your roller lagging needs and provide protection for your equipment.
Roller lagging operation process
1. Grinding roller
Clean up the residual glue on the drum, then use a special sander to polish the surface of the drum without any rust spots, and finally use a fiber disc to polish it gently;
2. Clean the surface
Use a cleaning brush to clean the polished surface, and then use a cleaning agent to clean it to ensure that there is no residue on the surface of the roller. If there is water on the surface of the drum, it should be dried;
3. Apply the adhesive
First, apply the metal treatment agent thinly and evenly to the grinding surface of the roller and let it dry completely. Then mix the hardener mixed in a specific proportion evenly to brush on the cylinder, wait for it to dry completely, and then brush for the second time, and at the same time brush the back of the rubber sheet again;
4. Paste the glue board
When it is dry to a little sticky, paste the rubber sheet, and roll it with a compaction roller. Hammer the rubber sheet firmly with a rubber hammer to ensure that there are no air bubbles inside. Finally, use a glue gun to fill the seam and polish and trim the edges.






