The anti-wear work of equipment is a systematic project. Different manufacturers have different construction methods, and the results will be very different. At present, the construction steps of our wear-resistant ceramic liner are generally to repair and polish the equipment, and then Gluing, gluing, pasting, curing, special products also need welding and other work.
These tasks seem simple, but they are more difficult to implement. This is a time-consuming job that requires careful and experienced, and is not something that can be done by a makeshift team. Unfortunately, some users attach great importance to the choice of the lining and viscose, but ignore the control of ceramic liner construction.
In order to save costs, some manufacturers often set up temporary construction teams in the local area. These temporarily formed teams are difficult to control in terms of operation skills and sense of responsibility, resulting in the rapid fall off of the expensive wear-resistant ceramic liner, which fails to achieve the expected anti-wear effect.
In order to save costs, some manufacturers often set up temporary construction teams in the local area. These temporarily formed teams are difficult to control in terms of operation skills and sense of responsibility, resulting in the rapid fall off of the expensive ceramic tiles, which fails to achieve the expected anti-wear effect.
Reasons for the wear-resistant ceramic liner to fall off during use:
1.Before the ceramic liner is adhered to the surface of the steel parts, the steel parts are not well treated.Some are not completely rust removed, and some are not smooth on the surface. In order to obtain a good construction effect, the steel parts must be pretreated by sandblasting. It is also necessary to wipe the steel surface with acetone to achieve a certain degreasing and degumming effect.
2.The ratio of wear-resistant ceramic adhesive is wrong.Different adhesive have different ratios, it must be strictly controlled, and the ratio of inappropriate can not reach the predetermined viscosity.
3.The wear-resistant ceramic adhesive is not evenly spread, so the places where there is no adhesive or too little adhesive are easy to fall off. After the wear-resistant ceramic tile is constructed, it should be gently tapped with a rubber hammer, and the construction surface should be flat.
4.The wear-resistant ceramic liner must be clear about the working temperature before construction. The ceramic liner can withstand a high temperature of 1,000 degrees. Different temperature should choose adhesive with different temperature resistance, otherwise it is prone to wear-resistant ceramic lining as the temperature rises. The phenomenon of sheet falling off.It is suggested that you must choose an experienced construction team when constructing wear-resistant ceramics. Good wear-resistant ceramic construction can make the effect much better.
