Oct 09, 2022 Leave a message

Molding method of alumina ceramic products


The molding methods of alumina ceramic products include dry pressing, grouting , extrusion, cold isostatic pressing, injection, casting, hot pressing and hot isostatic pressing and other methods. In recent years, domestic and foreign development of filter molding, direct solidification injection molding, gel injection molding, centrifugal grouting molding and solid free forming and other molding technology methods. Different product shapes, sizes, complex shapes and precision products require different molding methods. Extract its commonly used molding introduction:


Grouting molding method: Grouting molding is the earliest forming method used in alumina ceramics. Due to the use of gypsum molds, the cost is low and it is easy to mold large-size, complex parts. The key to grouting is the preparation of alumina slurry. Usually water is used as the flux medium, and then the degumming agent and binder are added, fully ground and then vented, and then poured into the gypsum mold. Due to the adsorption of moisture by the capillary of the gypsum mold, the slurry is cured in the mold. When the wear plate is hollow grouting the mold wall adsorption slurry reaches the required thickness, the excess slurry needs to be poured out. In order to reduce the shrinkage of the blank, a high concentration of slurry should be used as much as possible.


Dry press molding: Alumina ceramic dry press molding technology is limited to objects with simple shape and inner wall thickness of more than 1mm, and the ratio of length to diameter is not more than 4:1. Molding methods are uniaxially or bi-directional. Presses are hydraulic and mechanical, and can be semi-automatic or fully automatic molding. The maximum pressure of the press is 200Mpa, and the output can reach 15~50 pieces per minute. Due to the uniform stroke pressure of the hydraulic press, the height of the pressed parts is different when there is a difference in powder filling. The pressure applied by the mechanical press varies depending on how much powder is filled, which can easily lead to differences in size shrinkage after sintering, affecting product quality.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry