1. Appearance inspection -- Randomly pull out a piece of equipment box to be shipped, and then check:
a. The flatness of the ceramic rubber composite lining board, without obvious deformation, should be measured with the steel plate ruler and the contour size and diagonal;
b. Check the appearance of ceramic pieces embedded in rubber, whether there are missing corners, cracks and the surface color is consistent;
c. Check the bonding between rubber plate and steel plate. For the purpose of corundum ceramic lining plate, pull the rubber plate around the steel plate by hand to see if there is the problem of warpiness and unfirm bonding;
d. Check the four bolts for the back installation of the steel plate and weld them. Whether the connection is firm and the size is correct.
2. After the above appearance inspection is qualified, the product can be entered into the laboratory for testing. If the appearance quality is not qualified, it needs to double the quantity of sampling inspection.
A. Take a ceramic sheet from the ceramic rubber composite lining board and grind it to detect the alumina content by chemical method;
b. Take a ceramic sheet from the ceramic rubber sheet, and then test the surface hardness, compressive strength, use of corundum ceramic liner, bending strength, water absorption and other indicators of the wear-resistant ceramic sheet through the test bench;
c. The adhesive connection between rubber plate and steel plate is tested by a special experimental tension machine to meet the requirements of the technical agreement of the contract.
d. Take a piece of rubber from the ceramic rubber composite lining board. After repeated bending, the rubber will not break and good elasticity will be considered qualified.





