1. Do not fill more beads than the upper limit (85%);
2. Sanding machines with different wire speeds choose beads of different materials;
3. Select bead with appropriate density for slurry of different viscosity;
4. Do not mix beads of different materials;
5. Try to use beads with uniform particle size;
6. Keep low speed when cleaning and sanding with beads; Mechanical speed regulation using point movement, stepless speed regulation
Adopt low speed zone (recommended shaft speed less than 1000rpm);
7. Regularly screen out the old beads less than the lower limit;
8. Periodically check whether there are cracks or grooves and other stress concentration areas at the location of the sander's separation device, discharge end cover and dispersion shaft.





