The crushing of zirconia beads is related to the quality of steel balls, equipment and abrasive materials.
The hardness between the rotor and the inner cylinder in the grinding chamber of the equipment is 80 or 65 for the ceramic machine, the wear and damage rate is high, or the linear speed of the sand mill is very high. 65 zirconium ball is also easy to wear. Pure zirconium ball will only ball smaller and smaller, and will not damage the ball.
The Mohs hardness of zirconia beads is 9. If you remove materials with higher hardness than it, such as aluminum, boron, diamond, glass powder, etc., it is equivalent to removing hard materials with soft materials. If zirconium silicate ball and 80 zirconium ball are used at this time, broken balls will appear. Even if 95 pure zirconia ball is used, the wear will be great, but at least there will be no broken ball.
In terms of quality, zirconium balls are formed in hot air, cold air or electrolyte. If the parameters of a key technology are not well controlled, fragile beads will be produced: bubble beads, snowman beads, tail beads and flat (oval) beads. Due to the existence of stress concentration area, these beads are easy to break in the grinding process, which is the quality problem of the ball itself. Therefore, the use of such products should be avoided as far as possible.





