Introduction of common specifications of wear-resistant ceramic linings
The wear-resistant ceramic lining board is a special corundum ceramic made of AL2O3 as the main raw material and rare metal oxide as the flux, which is calcined at a high temperature of 1700 degrees, and then combined with rubber and high-strength organic and inorganic adhesives. finished product. So what are the commonly used specifications and models of this product? I have simply compiled the following.
Common specifications of ceramic liner:
(1) 10×5×1.5mm. 10×10×1.5mm.
(2) 00010×10×3mm, 15×15×3mm.
(3) 17.5×17.5×3mm, 20×20×3mm.
(4) 20×20×5mm, 50×60×6mm.
(5) 50×60×8mm 120×80×25mm.
The wear-resistant ceramic lining plate has high hardness and can be customized to process various special-shaped parts, high-precision wear-resistant parts and ceramic-metal composite parts according to needs. Its Rockwell hardness is HRA80-90, second only to diamond in hardness, far exceeding the wear resistance of wear-resistant steel and stainless steel. Good wear resistance, its wear resistance is equivalent to 266 times that of manganese steel and 171.5 times that of high-chromium cast iron. Under the same working conditions, the service life of the equipment can be extended by at least ten times. Light weight, its density is 3.6-3.9g/cm3, which is only half of steel, which can greatly reduce equipment load.
