1、 Effect of zirconia bead selection on grinding
(1) Hardness
Mohs and Vickers are commonly used indicators. Generally, the higher the hardness, the lower the wear rate of beads. From the wear of the contact parts of the sand mill (dispersion plate, rod pin and inner cylinder, etc.), the wear of the beads with high hardness against the contact parts is greater, but the wear of the beads with smooth surface on the cylinder and dispersion plate is relatively small. At the same time, the better optimization point can be achieved by adjusting the filling amount of grinding beads, viscosity and flow of materials.
(2) Particle size
Its size determines the number of contact points between beads and materials. The more contact points of beads with small particle size under the same volume, the more effective collision times in the grinding process, and the higher the grinding efficiency. At the same grinding time, when using small diameter grinding beads, the product fineness is better than using large diameter grinding medium. On the other hand, when grinding materials with large initial particles, for example, for materials with 100 microns, beads with d = 1mm are not necessarily used because the impulse of small beads can not reach the energy of full grinding dispersion. At this time, beads with large particle size should be used.
(3) Density
Density is expressed by density (true density) and bulk density (false density) in normal documents. The molecular weight and percentage composition of various oxides determine the density of zirconia beads. Generally, the higher the density, the greater the kinetic energy generated with the rotation of the grinder and the higher the grinding efficiency. On the other hand, the higher the grinding medium density, the greater the wear of the contact parts (inner cylinder, dispersion plate, etc.) of the sand mill, so the matching of material viscosity and flow becomes the key. Low density zirconia beads are suitable for low viscosity materials, and high density zirconia beads are suitable for high viscosity materials.
2. Reasonable filling rate
The filling rate is the number of grinding beads required by the sand mill for better dispersion grinding effect. The filling rate of grinding beads is too high, which is easy to cause the internal temperature of the grinder to rise, and the cylinder can not dissipate heat in time and shut down automatically. The filling rate of grinding beads is too low, the grinding efficiency is low and the medium loss is large. Therefore, reasonable filling rate is one of the important factors to improve grinding efficiency.
The filling rate is often expressed by volumetric method in the operation manual of sand mill, but it must be converted into the actual filling quality of medium in production. Calculation formula = effective volume of sand mill × Filling rate × Bulk density of grinding medium
2、 Supplement grinding medium
1. Principle of adding grinding medium
If the grinding efficiency of the grinder is found to be reduced, it is a possible signal to add beads. Users can screen and add beads regularly according to their own process conditions and master the actual loss rate of beads.
2. How to supplement grinding medium
Due to the natural loss of beads, the particle size of beads will be smaller and smaller. In order to maintain a unified filling amount and avoid fine beads from blocking or entering the separation device, the beads should be screened and a certain amount of grinding medium should be supplemented according to the service life of grinding medium and the conditions of user's own process. Shanghai rute's suggestion is to check the wear of beads after 500-600 working hours and reasonably add an appropriate amount of new beads.





