Jul 18, 2022 Leave a message

What Kind Of Wear-resistant Zirconia Beads Should Be Used For Different Sand Mills?

Centrifugal Sand Mill

The high-speed rotating grinding cylinder and the low-speed rotating shaft generate radial centrifugal force to force the material to complete dispersion and grinding in the shear zone away from the axial separator, which can handle ultra-fine and low-viscosity materials. The particle size of the grinding beads can be 0.05 -0.80mm range to choose. Zirconia beads are recommended.


Open Vertical Sand Mill

It is improved from the vertical stirring ball mill, and the continuous production of large flow is realized by the method of bottom feeding and top open discharging. The volume can reach 5000L, and the compressive strength of the beads is low. It is recommended to use ceramic beads for 2.0-3.0mm vertical sand mill.


Traditional Horizontal Sand Mill

It can be considered that the grinding cylinder of the closed vertical sand mill is formed by lying horizontally, which increases the filling amount of beads and improves the grinding efficiency. Use zirconia beads with a size of 1.0-3.0 mm of grinding beads.


Bar Pin Horizontal Sand Mill

One of the revisions of the traditional horizontal sand mill, changing the dispersing disc into a rod pin. Typically zirconia beads of 0.6-2.0mm particle size are used.


Closed Vertical Sand Mill

It is formed by restricting the discharge port on the top of the open vertical sand mill. It works under pressure and can handle materials with relatively high viscosity. The agitator adopts a dispersing disc or a rod pin, and the model is relatively small, usually with a size of 0.6- 3mm grinding beads can be configured with zirconium silicate beads or zirconia beads.


Turbine Horizontal Sand Mill

It is one of the revisions of the traditional horizontal sand mill, changing the flaky dispersion disc into a thick turbine with an inner cavity. Grinding beads with a size of 0.4-2.0mm are usually used, and zirconium silicate beads or zirconia beads are recommended.


Special-shaped Dispersing Disc Sand Mill

By using different shapes of dispersers, such as gear-shaped, eccentric and tower-shaped, to change the way of transmission capacity, the ultimate goal is to change the direction of movement of the beads and increase the return rate, thereby reducing the accumulation and delamination of beads. Grinding beads of 0.6-2.5mm diameter can be used. Depending on the shear force, zirconium silicate beads or zirconia beads can be selected.


Special-shaped Cylinder Sand Mill

There are usually two types: conical horizontal type and octagonal vertical type, which can improve the useful work ratio of grinding beads by changing the flow gradient and direction of grinding beads and slurry. Usually 1.0-2.0mm zirconium silicate beads are used as grinding media.


Basket Sander

The grinding basket with agitator is immersed in the closed cylinder, and the high-speed rotating turboprop generates eddy current to make the material continuously disperse and grind through the high-speed moving grinding beads in the basket. The particle size of the grinding beads can be selected between 1.0-3.0mm. Usually zirconium silicate beads or zirconia beads are used.


Ring Sand Mill

The "W" grinding channel is formed by the rotor (shaft) and the stator (grinding cylinder with special structure). On the one hand, the residence time of the material in the grinding cylinder is increased by increasing the grinding channel, and on the other hand, the heat dissipation area of the cooling system is increased to reduce the output. material temperature and improve grinding efficiency. Beads of 0.4-1.5mm are commonly used sizes. Zirconia beads are recommended.


INDEX


Production Image

_20220228083553


_20220228083615

Send Inquiry

whatsapp

Phone

E-mail

Inquiry