The anti-wear effect of the wear-resistant ceramic lining plate on the feeding chute
We once received a consultation from a cement factory on the anti-wear solution for the cutting chute with wear-resistant ceramic linings. Through communication and exchanges with customers, we found that due to high-speed material scouring, the shell of the powder separator chute is very easy to be worn out. Once When the chute casing was worn through, they had to shut down for maintenance, seriously affecting production efficiency.
Our company uses high-grade alumina raw materials, and the wear-resistant ceramic linings produced are fired in tunnel kilns up to 1700°C, and the Rockwell hardness is as high as 87HRA, which is second only to diamond in hardness.
As determined by the Institute of Powder Metallurgy of Central South University, its wear resistance is equivalent to 266 times that of manganese steel and 171.5 times that of high-chromium cast iron, and its wear resistance far exceeds that of conventional wear-resistant materials such as wear-resistant steel and stainless steel; under the same working conditions In addition, the density of ceramics is 3.65g/cm3, and its density is only half of that of steel. Installing wear-resistant ceramics inside the chute can reduce the overall load of the equipment and greatly improve the The service life of the chute reduces the user downtime for maintenance. While improving the overall production efficiency, it also creates additional economic benefits for customers








