May 24, 2021 Leave a message

Operation Methods And Common Problems Of Wear Resistant Ceramic Adhesive

Wear resistant ceramic glue is a key special tool for fixing the inner lining of wear-resistant ceramic tube. Its operation method is very different from that of general strong glue. Let's talk about the actual operation method of wear-resistant ceramic glue.


1. Dust removal by grinding. Before sticking the wear-resistant ceramic pieces, the first thing to do is to polish and remove dust and rust at the position of the machine and equipment to be pasted until the original tone of the exposed metal material is cut off. After polishing, the paint thinner such as ethanol must be used to carefully clean up, and then the porcelain can be pasted.


2. Glue preparation. Under the indoor temperature standard, mix the main adhesive and epoxy curing agent according to the proportion of 2:1, mix evenly, and use up within 30 minutes after configuration, so as to prevent early drying.


3. Wipe. In the already polished and cleaned position of the glue, must be coated, can't have lack of glue. And the front face and four sides of the porcelain must be coated with glue, and the gaps between the porcelain must be covered with glue.


4. Bonding. After dispensing, cut the adhesive tape with a knife head, and tamp the ceramic plate with a mallet to let the unnecessary adhesive out. In order to ensure the adhesive compressive strength, the thickness of the adhesive should be maintained within 0.5mm.


5. Glue filling. The gap in the middle of the ceramic plate should be made up with wear-resistant ceramic glue, the gap size should be maintained within 1 mm, the primer should be evenly coated, and there should be no overflow.


6. Dry solid. After the ceramic plate is pasted, it can be dried for 24 hours to two days.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry