How to weld the alumina wear-resistant ceramic lining plate?
Each equipment will be constantly impacted and rubbed by materials during operation, and some equipment will run for a long time without interruption, which will shorten the service life of the equipment, so the lining is lined with alumina wear-resistant ceramic lining to increase its service life. , can also reduce the cost of the factory. So how to apply the alumina wear-resistant ceramic lining to the equipment?
On the surface of the equipment, first of all, the rust, dust, oil, etc. on the surface of the equipment need to be cleaned with a detergent.
After mixing the wear-resistant ceramic glue, when there are no air bubbles, apply wear-resistant ceramic glue to the alumina wear-resistant ceramic lining and fix it on the equipment, and tap it with a small hammer to remove the air bubbles, so that the alumina The wear-resistant ceramic liner is more suitable for the equipment, and it can be completely bonded to the inner surface of the equipment.
Check for protrusions, degumming, bad seams.
Wait for the wear-resistant ceramic adhesive to fully cure on the device.






