The arc welding of alumina ceramic structures is different in both mode and nature, which are related to the factors such as gas, pressure and electrode material used in the arc welding process. Therefore, arc welding of oxygen and its structural parts can be simply divided into two categories: non self restraint discharge and self restraint discharge. In the non self restrained discharge of arc welding of alumina ceramic structure, the initial charged particles will be caused by the high profile of external electricity, showing a dark discharge state.
However, when the external ionization source is cancelled, the dark discharge will stop immediately. When the current used for arc welding of alumina ceramic structures exceeds a certain range, the gas conductive process itself can produce charged particles required to maintain conductivity. In this case, even if the external ionization source is cancelled, the discharge process can continue. This
phenomenon is the so-called self-restraint discharge. Alumina ceramic structures also have thermal conductivity when used, that is, the heat passed by alumina ceramic structures per unit area in unit time and unit temperature gradient. The thermal conductivity of alumina ceramic structure is of great significance, so it must be measured accurately. There are two methods to measure the thermal conductivity of alumina ceramic structures. One is the steady-state method, which is measured by a flat plate thermal conductivity meter. In the steady-state test, the alumina ceramic structure to be tested is in a stable temperature field. Measure the heat flow rate per unit area, the temperature change in the heat flow direction and the volume of alumina ceramic structure, and then calculate its thermal conductivity according to the specified calculation formula. Another method is the unsteady state method, in which the cross hot wire method is more used to measure the temperature change of the linear heat source embedded in the alumina ceramic structure along its direction in a certain time, so as to obtain the thermal conductivity of the alumina ceramic structure.





